Choose your language and timezone. (Example: “English and “Brussels”) On your remote control, locate “Start using TVIP” and press OK Go to “Settings”
In “Network” section, you’ll find your “MAC address”, write it down because you’ll need it to notify us so we can confirm/activate your account in our system.
In “Display” section, make sure “HDMI auto frame rate” is set to “ON”.
Some newer tv’s can have problems synchronizing hz/fps and you can experience FPS lagg if you dont enable this option.
In “TV” section, it should look like the following :
Stream source: Multicast
MPEG-TS buffering, msec: 5000
DVR storage: No storage
Timeshift storage: Internal storage
Content source: Web portal Below there is a button called “Setup Web portal”, enter it and view the following settings:
Portal URL: (here is where you will write down the portal link you get from us) Portal manager: Off Use web portal: Whole system API mode: MAG
Press “Apply” when done
The TVIP S-Box will reload and you are now ready to watch TV
Note: Sometimes the “MPEG-TS buffering, msec: 5000 resets it’s value so be sure to check when you reboot if the value is still 5000 and make sure you set it back to it again.
For more information visit http://www.iptvlive.com